General Specifications

Dimensions (TZ5)	    	    mm		ft	in
	Length		    6,058		19'	11"
	Width		    2,438	  	8'	0"
	Height		    2,591	  	8'	6"

Capacity				
			Imperial		U.S.		
	Liters		Gallons		Gallons
	24,000		5,281		6,340
	25,000		5,500		6,605
	26,000		5,720		6,870

Shell Material		Stainless steel, A 240 316 (316533). 
Frame Material		Structural steel to BS 4360 Grade 50A, B & C. 
Shell Thickness		Shell and ends 4.47 mm and 4.70 mm respectively.



Working Pressure			4 Bar (58.0 psi)
Test Pressure			6 Bar (87.0 psi)
External Vacuum Pressure		0.41 Bar (5.9 psi)
Design Temperature		-40/140C (248F)
Design Code			ASME VIII Division 1



External Finish		Framework shot blasted to SA 2.5 and painted using 
			a vinyl co-polymer resin.

Internal Finish		Better than 180 grit with the total interior acid cleaned,
			and certified for the carriage of  foodstuff.



Weights			Kgs.		Lbs.
Max Gross		36,000		79,365
Tare			  3,550	  	7,826
Max Payload		32,450		71,539






Fittings 

Manlid		Fort Vale 500 mm, low profile fully hinged with 8-point fixing 
		complete with stainless steel swing bolts with naval brass handnuts.

Air Line		1.5" BSP stainless steel butterfly valve fitted with an integral 
		flame arrester.  Terminates in a 1.5" BSP dustcap with a 
		retaining wire. Facility for pressure gauge connection exists.

Bottom Outlet	3" 45 deg combination bottom outlet.  3" foot valve with clamped
		3" butterfly valve with 3" BSP threaded connector with stainless
		steel cap and retaining chain. Remote control connected to internal
		valve-kick cable type. Fusible link fitted when applicable.

Top		3" nominal bore with removable siphon tube, 3" butterfly valve
		Outlet and 3" Table 'D' blank flange.  

Safety Relief	One 3" BSP "Super Maxi" high flow pressure relief valves set 
Valves		at 4.4 bar (63.8 psi). Provision for second SRV

Top		All top fittings are housed in two stainless steel spill boxes 
Compartments	complete with stainless steel drain tubes.



Insulation	50 mm thick Isowool.  Complete outer cladding of 0.8mm thick
		aluminum marine grade 5754 mill finish with swaged joints.

Steam Heating	Comprising of 10 longitudinal stainless steel channels (2.5 x 2.5 x 100mm). 
System 		Effective heating area of 10 sq. meters (107sq. ft.) with 6 BAR (87 PSI) MAWP.  
 		Outlet: 3/4" BSP connection with plastic cap and retaining wire. 
		Inlet: 1" BSP connection with plastic cap and retaining wire.
			
Thermometer	One Contact type analog from -40ºC to 160ºC with dual ºF readings
		Located at the rear end.

Approvals	BV, ADR/RID, T-11 IMDG, IM101 (US) DOT, (UK) DOT, IMO Type 1, UIC,
		TIR, CSC, AAR 600, TC Impact Approved.  FRA, DIR (Australia).